Description
The Door Decker Finishing System consists of two steel plates with handles on each attached with brass eyelets. Each plate is securely screwed into the center of either end of a door with a 8 x 1 1/4 inch Phillips wafer head screw (included with purchase) prior to painting or stain application. Other sizes/types of screws can damage the brass eyelet and weaken the handle over time. One pair used on each door is the best method for the average height/weighted door. Once the Door Deckers are attached, painting can begin. Spray one side and then with one person on each end of the door, flip the door and spray the opposite side. Then move the door to an out-of-the-way location for stacking and drying. Continue the process with each additional door. The interlocking system of the steel plates allows for the Door Deckers to balance against each other while stacked. This horizontal painting and drying process creates application finishes without runs or sags and stacked up and out of the way for drying - great for saving space on a job site.
