Description
Paver & Concrete Sealer – 2 Component 10 Gallon Kit
- Waterborne
- Wet-Look Sealer
- Eco-Friendly
- Protects from Stains
- Locks down Joint Sand
Clear Seal is a water-based sealer for concrete pavers, natural stone and concrete surfaces. This eco-friendly and low VOC product provides the same wet look and protection as solvent-based sealers, and may be applied on damp surfaces which allows pressure cleaning and sealing on the same day. Once applied, Clear Seal helps lock down joint sand and inhibits weed growth between pavers. It will also help protect surfaces against gasoline, oil and tire marks. May be used as a top coat over other colored stain products.
Directions:
Clean surface and ensure it is free of contaminants before sealing. Allow concrete surfaces to cure for at least 28 days before sealing. Prior to application, a muriatic acid etch is recommended. Clear Seal contains a part A and part B that must be mixed together prior to application. Part A is in a 6 gallon pail and Part B is packaged in a 1 gallon jug. These packages are partially filled by design. Pour 1 jug of Part B into Part A and mechanically mix for as much as 5 minutes or until solution is clearly homogenous. Then, pour half of resulting blended concentrate into another empty 5 gallon pail. Fill remainder of each pail up with water, ensuring full dilution, and then apply with roller or sprayer. Apply a uniform coat heavy enough to wet out joints if sand stabilization is desired. A second coat of sealer may be appropriate depending on the porosity of the substrate. If required, apply second coat after 4-6 hours of drying time. Each fully diluted gallon of product will cover approximately 200 square feet of ground. Following application, Allow 2 hours for surface to dry (non-stick) and 48 hours for curing.
